New York Harbor Water Siphon Replacement

Photo of New York Harbor Water Siphon Replacement

New York City Economic Development Corporation

Brooklyn, NY to Staten Island, NY

Water for Staten Island and Bigger Cargo Ships for New York Harbor

View an interactive map of the project.

Challenge

In 1917 and 1925, two water mains (known as siphons) were built to carry drinking water from Brooklyn to Staten Island. Located at depths of 56 and 60 feet, they were laid into trenches at the bottom of the harbor in 12-foot lengths connected by flexible joints. No longer used as Staten Island’s primary source of water, the two siphons currently provide a backup to the 900-foot-deep hard-rock Richmond Tunnel, which went into service in 1970.

The Port of New York and New Jersey is the third largest port in the country, handling almost 40% of the East Coast shipping trade. The port provides more than 279,000 jobs to the local economy and $12 billion in annual wages. In 2011, the port handled record volumes of cargo, processing 5.5 million TEUs or twenty-foot-equivalent units. Cargo volumes are expected to double over the next ten years, and may quadruple within 40 years.

The port’s Anchorage Channel is 45 feet deep — not deep enough to accommodate the next generation of cargo mega-ships. Dredging operations are under way to deepen the channel to 50 feet below the mean low-water level over a 19,000-foot stretch from the Verrazano Bridge to the Port Jersey Channel.

Because the deeper channel may compromise the two aging water siphons, the New York City Economic Development Corporation launched a project to replace them with a larger and deeper siphon. The project required boring a tunnel under full hydrostatic pressure, through highly variable clays and sands.

Solution

In 2005, HMM was retained as a Joint Venture partner to evaluate alternatives for replacing the existing siphons with one new 72-inch-diameter steel pipeline at a sufficient depth. Alternatives included wet trench cut-and-cover, horizontal directional drilling, microtunneling, and tunneling either through relatively shallow soft ground or through very deep rock.

HMM considered environmental impacts, impacts on shipping traffic, permitting challenges, scheduling risks, cost risks, and operations and maintenance challenges.

HMM recommended the use of a 72-inch-diameter steel siphon inside a tunnel with an overall diameter of 12 feet. The outer tunnel would be bored through soft ground at a depth of 100 feet and constructed with precast segmental lining.

HMM’s recommendation was accepted, and HMM was retained to provide overall project management for the Joint Venture. HMM is responsible for the design of the tunnel and siphon, the structural design of all valve chambers, and the abandonment of the existing siphons and their associated chambers. In addition to the water crossing, the project includes several thousand feet of water transmission mains on land, to connect the new siphon to existing pipelines.

Water mains on the land side include 20-inch ductile iron mains, and 60-inch and 72-inch steel mains. Several chambers contain butterfly valves, gate valves, pressure-regulating valves, blow-offs, and flow meters.

The project also requires two trenchless crossings of the Staten Island Railroad, with 60-inch steel pipe installed in 84-inch steel casings. Passive cathodic protection is provided for all land-side steel pipelines.

The project also includes a new chlorination station on Staten Island, able to treat 150 million gallons of water per day. HMM performed electrical, instrumentation, structural, and architectural design of the chlorination station, and is providing quality control reviews of all elements of the project designed by our Joint Venture partner.

The tunnel, under construction as of 2013, is the first major underwater soft-ground water tunnel in New York City, and the first tunnel of any kind built under the harbor in many decades. A mixed-face earth pressure bound tunnel boring machine is being used to bore the tunnel, with train tracks transporting workers, equipment, and excavated soil to and from the tunnel. HMM has coordinated the participation of agencies including the New York City Economic Development Corporation, New York City Department of Environmental Protection, Port Authority of New York and New Jersey, and the US Army Corps of Engineers.

Benefits

Ocean shipping is one of the most economical and environmentally sustainable means of transporting freight. According to the New York City government, new and larger “Post-Panamax” vessels offer additional environmental benefits by carrying more cargo in fewer ships and making use of cleaner fuel technology.

The new 100-foot-deep water siphon will enable these bigger vessels to navigate New York Harbor. The new siphon will provide five million gallons of water per day under normal conditions and up to 150 million gallons per day in an emergency.

Speaking in April 2012, Mayor Mike Bloomberg said, “New York Harbor has been a critical part of our economy since the founding of our great city some 400 years ago. And if we want New York City’s economy to stay competitive, we must accommodate new mega-ships and their cargo. This investment in our infrastructure will spur economic activity all along our working waterfront.”

Carter Strickland, Commissioner of the New York City Department of Environmental Protection, said, “World-class NYC Water will continue to flow to Staten Island for future generations because of this siphon.”

Staten Island Borough President James Molinaro said, “The dredging of the Harbor will allow Staten Island’s shipping and receiving industry to remain competitive throughout our region, protecting existing jobs and encouraging the development of new ones. Additionally, the new water siphon will ensure that our Borough’s water needs are met, especially as our population continues to grow.”